Features:
●1. Wear-resistant, recyclable.
●2. Easy to use in DIY operation.
●3. Balance tiles in the same horizontal position.
●4. Improve the installation speed of tile.
●5. Reduce the fatigue/pressure of installers.
●6. There are hardly any crackles, flat surface.
●7. It reduces the need for grinding and polishing.
●8. Prevent tiles from moving during solidification.
Specifications:
Name: Steel Needles for Tile Levelling System
Material: stainless steel
Length of steel needle: 32mm/1.26"
Thickness of steel needle: about 1.5mm
Type:100pcs Steel Needles
Use Tips:
Lay the first tile, leaving more than 2mm (with cross gaskets). Close to tile.
Insert T-pins along the gap between tiles.
Then rotate 180 degrees and the T-needle is stuck at the bottom of the two tiles.
Adjust the lid with a hand/special wrench until the two tiles are on the same level.
After levelling, about 5-6 hours, before the cement/binder is completely dry, rotate the lid in reverse and take out the 180-degree T needle until the word is removed.
Avoid not removing the T-tile levelling system:
1. Ceramic tile gaskets are 2mm or more (cross gaskets are recommended)
2. When levelling, the cement or tile adhesives around T-type leveller must be cleaned.
3. Remove the T-type straightener about 5-6 hours after levelling before the tile binder or cement is completely dried.
Included:
100 * Steel Needles
Note:
*1. This item only contains steel needles and does not include a leveller. The leveller in the picture is just the effect of using.
*2. The real colour of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
*3. Please allow slight manual measurement deviation for the data.
